Optional Controller
Manual of Controller
2 - 9
1. Timer Remote Controller (CZ-RTC4)
15
(EN)
You can duplicate the preset program by day.
Select the copy source.
1
If [PROGRAM]([COPY]) is pressed
in program checking mode
, it
enters the copy mode (Selecting
the copy source
) of the program
timer.
While in the copy mode of the program
timer, [SETTING] and
(day) of the copy
source ash on the display.
A
1 2 / 4 3 / 4
2
Press [▼/▲] to select the day of the
copy source.
Select the copy destination.
3
If [SET] is pressed in the mode of
selecting the copy source
, it
enters the copy mode (Selecting the
copy destination
) of the program
timer.
4
Press [▼/▲] to select the day of the
copy destination. Then, press [SET]
to complete copying and return to
the program checking mode.
Weekly Program Function
Note
The program will be overwritten if the preprogrammed day is selected as a copy
source.
Duplicating the Program Timer
14
(EN)
Weekly Program Function
Invalidating the Program Timer
If you want to stopping the program operation for more than 1 week, you can invalidate
all the timer settings.
Once the timer settings are invalidated, the program will not be operated until the
invalidation is cancelled.
How to invalidate the program timer
1. Press and hold [CANCEL]([TIMER
OFF]) for more than 2 seconds.
[TIMER OFF] is displayed and the programs will
be invalidated from the next one.
A
1
How to cancel the program timer invalidation
1. Press and hold [CANCEL]([TIMER
OFF]) for more than 2 seconds.
[TIMER OFF] disappears and the programs will
be validated from the next one.
A
1
If Power Failure Occurred
If the power recovers in a short time period, the program after the recovered time will
be valid.
If more than one hour has passed for power return after power failure, the present time
information will be lost. In this case, the program will not be operated.
SM830241-00_2WAY SYS.indb 9 2015/03/26 14:54:54
To Next Page
Loading...
Need help?
General
