Panasonic CZ-RTC4 Service Manual

Optional Controller
Manual of Controller
2 - 12
1. Timer Remote Controller (CZ-RTC4)
21
(EN)
 If [Sleeping] button does not work.
Or, in the case of operation not being started even if [SET] is pressed. Check the following table.
Item
Display of the remote control unit (Lighting/ ashing indication)
Contents
1
The Error indication  ashes
(for several seconds).
The clock is not set.
2
“This function is not available” indication
lights up (for several seconds).
When the operation mode is set to AUTO or FAN, this function is not available.
3
Centralized control indication  ashes
(for several seconds).
The centralized control device is prohibited from starting/stopping the unit or changing the temperature setting.
The sleeping function operation will be cancelled in the following cases: 1: When the unit is operated to stop or change the temperature setting by the other remote
control unit or centralized control device.
2: When the unit is operated to stop or change the temperature setting with the weekly program
function / outing function.
3: When the centralized control unit is prohibited from stopping the unit or changing the
temperature setting.
Note
Trouble Possible Cause/Remedy
The temperature setting does not decrease (increase).
The temperature over the upper or lower limit or each operation mode cannot be set.
Operation under the sleeping function does not  nish.
Note if you change the time after the sleeping function started. The operation does not  nish until it reaches to the set starting time.
20
(EN)
Ex. In case of 7 hours timer 1
Press [Sleeping]. • Each time the button is pressed, the
indication changes in the following order.
(every one hour)
(Press [CANCEL] to stop the time setting.)
A
2 11
2
Press [SET]. • The sleeping operation starts.
 When the off time comes:
• The indoor unit stops.
* The temperature returns to the setting at the time when sleeping function
operation started.
To cancel the sleeping function operation
1. Press [Sleeping].
* The temperature setting remains at the time
cancelled.
A
1
• The following buttons also cancel the sleeping function operation.
[Start/Stop] button Stops the indoor unit after the sleeping function operation is cancelled. [Mode select] button Changes the operation mode after the sleeping function operation is cancelled.
SM830241-00_2WAY SYS.indb 12 2015/03/26 14:54:55

Panasonic CZ-RTC4 Specifications

General

Brand	Panasonic
Model	CZ-RTC4
Category	Remote Control
Language	English