5-72 DBS 576 (USA) issued September 2001 576-50-700
Chapter 5. Key Telephone Features Section 700 - Operation
Operation
To make a page:
Meet-Me Answer
To answer a page using Meet-Me Answer:
Hardware Requirements
• External relays, amplifier, and speakers are required for external paging.
Related Programming
• FF1-0-02: Paging Override
• FF1-0-03: Extension COS (Paging)
• FF1-0-04: Trunk COS (Paging)
• FF1-2: Dial Plan
• FF2: Trunk COS
• FF3: Extension COS
Considerations
• You can assign the paging access code to a one-touch or FF key. Beginning with Version 3.5 and
higher, the assigned FF key LED indicates whether the paging system is in use. If the paging
system is not in use when a page is originated, the FF key LED lights solid green on the
originator’s telephone. If someone in the paging group initiates a page, assigned FF key LEDs on
all other telephones will light solid red until the page has been terminated.
• If an external paging system has been connected, pages can be made to paging groups 0-9
through the external speakers. Voice paging can also be heard over the extensions in groups 0-9.
• An extension can belong to more than one paging group.
• Only one page may be performed at a time. If you attempt to make a page while another
extension is paging, you will receive a busy signal unless your system allows Paging Override.
• Beginning with Version 3.5 and higher, the paging system can be set to “timeout” if a page is
longer than a specified length of time (0 to 255 seconds). If this feature is set and the timeout
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Enter the Group Paging code (default = #).
3. Enter the number of the desired paging group (0-9).
4. Make your announcement.
5. Replace the handset or press the ON/OFF key.
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Enter the Meet Me Answer code (default = ##). Connected to specified party
To Next Page
Loading...
