4-14 DBS 576 (USA) issued September 2001 576-50-700
Chapter 4. User Maintenance Section 700 - Operation
Hardware Requirements
•N/A
Related Programming
•N/A
Considerations
•N/A
Set Message Key ID Code
Description
(For a description of the Message Key ID Code Feature, see “Message Key ID Code” on page 3-63.)
On a large display phone you can use a Message key to either retrieve voice mail messages or respond
to telephone messages. To respond to voice mail messages from a 3rd party voice mail system, you
need to set the Message Key ID code to identify the caller to the voice mail system. You can also use
the Message key to program a voice mail password.
Operation
To set the Message Key ID code:
13. Repeat steps 8-12 until all extension names are entered.
14. Press the AUTO key to exit the entry mode. Enter EXT # displays
15. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
81-
User MAINT displays
OR...
ON/OFF LED goes off
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 4-3.)
81-
User MAINT displays
2. At the 81 level, enter 06.
3. Press the HOLD key. 8106-
MSG Key ID Code displays
4. Press the HOLD key. MSGID-EXT Number displays
5. Dial the extension number of the phone being programmed.
6. Press the HOLD key. MSG-ID EXT XXX displays (where
XXX = extension number)
Action Result
To Next Page
Loading...
