Panasonic DBS-576HD - Manual Day;Night Mode

Section 700 - Operation Chapter 3. System Features
576-50-700 DBS 576 (USA) issued September 2001 3-25
Manual Day/Night Mode
You can manually change the System mode to Day 1, Day 2, Night, Night 2, or Night 3 mode by
either entering the correct dial code or by pressing the appropriately programmed FF key.
When using manual mode, the System may be configured to either use MCO tenant Day/Night modes
or system-wide Day/Night mode.
Operation
To switch Day/Day 2/Night modes using Feature Access Codes (CPC Ver. prior to 2.0):
Night 1 Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night 1 Message
Night 2 Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night 2 Message
Switch Mode Procedure Indication
Toggle Day 1,
Day 2, and Night
Modes
1. Press the ON/OFF key. Intercom dial tone
ON/OFF LED lights
2. Enter 760.
3. Press the ON/OFF key ON/OFF LED goes off
If changing to Night mode, Red LED lights
If changing to Day mode, Red LED goes off
Day 2 Mode
1. Press the ON/OFF key. Intercom dial tone
ON/OFF LED lights
2. Enter 761 for the Day 2 Feature
code.
3. Press the ON/OFF key ON/OFF LED goes off
Green LED lights
Night 1 Mode
1. Press the ON/OFF key. Intercom dial tone
ON/OFF LED lights
2. Enter 762 for the Night 1 Feature
code.
3. Press the ON/OFF key ON/OFF LED goes off
Red Night LED lights
SYSTEM
MODE
TRS RING ATTENDANT
BUILT-IN
VOICE
PROCESSING
UNIT