6-18 DBS 576 (USA) issued September 2001 576-50-700
Chapter 6. DSLT Features Section 700 - Operation
Floating Hold is useful when the intended recipient of a call must be located via a page. The call can
be placed in a Floating Hold “orbit” and that orbit number announced during the page. The paged
party can then pick up the call by dialing the orbit number.
Operation
To place a call on Floating Hold:
To retrieve a call from Floating Hold:
Hardware Requirements
•N/A
Related Programming
• FF1-0-01: Floating Hold on HOLD Key
• FF1-0-02: Dial Control for Floating Hold Answer.
• FF1-2: Dial Plan
Considerations
• The number of floating hold orbits available may very depending on the Station Park/Floating
Hold Pickup setting (FF1-0-02-0025). The floating hold pickup access code can set to *9
(default). The “*9” access code operates as follows:
Exclusive Hold
With Exclusive Hold, only the extension that held the call can retrieve it. Exclusive Hold can be used
to hold CO calls and extension calls.
Action Result
1. Press the HOLD key. Intercom dial tone
Action Result
1. Enter the Floating Hold Pickup feature access code (default
= *9).
2. Enter the Floating Hold orbit number (001-576 (CPC-288/
576), 01-96 (CPC-96) or 001-099 (CPC-288/576) or 01-09
(CPC-96) (See considerations below.)
System Size Virtual Line Number and Operation
96
01-09 Floating Hold pick up
10-96: For Station Park Hold pick up purpose
Above 96
001-099 Floating Hold pick up
100-576: Station Park Hold pick up purpose
To Next Page
Loading...
