Section 700 - Operation Chapter 7. SLT Features
576-50-700 DBS 576 (USA) issued September 2001 7-31
Operation
After receiving an offhook signal during a call:
OR
NOTE: The steps outlined above can be performed only when the necessary settings have been
programmed into the system.
Hardware Requirements
•N/A
Related Programming
• FF3: CO Off-Hook Signal
• FF1-1: Off-Hook Signal Timer
Considerations
• The CO call type may be either multiple ring, or DID/DIL whose destination is set to Auto camp-
on (Call Waiting).
• Offhook signaling is not supported for an ISDN terminal.
• The System does not send the offhook signal under the following conditions:
• During a conference call
• During an OHVA or Busy override
• Data Privacy is enabled
• Receiving telephone is a 3rd party voice mail.
Offhook Voice Announce
Description
You can interrupt a busy extension when making an Intercom Call, and then use the Off-Hook Voice
Announce (OHVA) feature to make an announcement.
Action Result
1. Complete the first call and place the handset on hook. First call is terminated.
2. After the telephone rings, go off hook. Incoming call is answered.
Action Result
1. Press and release the hook quickly (hookflash). First call is placed on hold; incoming call
connects.
2. Press and release the hook quickly to go back to the
original call.
First call connects again.
To Next Page
Loading...
