7-24 DBS 576 (USA) issued September 2001 576-50-700
Chapter 7. SLT Features Section 700 - Operation
To use Manual Camp-on:
To answer a Camp-on (Call Waiting) signal:
Hardware Requirements
•N/A
Related Programming
•FF1-2: Dial Plan
• FF1-0-03: Extension COS
• FF3: Extension COS
Considerations
• You can transfer an outside call to a busy extension using Camp-on. See “To camp a call onto a
busy extension:” on page 266.
Conference Calls
Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration, up to 3 parties can be included in a conference call at any time.
Note: The SLT does not support 8-party conference calling.
The system supports the following types of three-party conference calls:
• 3 extensions
• 2 extensions and 1 CO line
• 1 extension and 2 CO lines
Action Result
1. Lift the handset. Intercom dial tone
2. Dial the extension number. Busy tone
3. Enter the Camp-On (Call Waiting) code (default = 2). • Called party hears alert tone
• Calling party hears ringback tone
4. Remain on the line until the called party answers.
Action Result
1. Replace the handset.
2. Lift the handset again to be connected to the waiting call.
OR....
Hookflash.
• Current call placed on hold
• Connected to waiting call
To Next Page
Loading...
