Section 700 - Operation Chapter 6. DSLT Features
576-50-700 DBS 576 (USA) issued September 2001 6-21
To retrieve a transferred call park:
Hardware Requirements
•N/A
Related Programming
• FF1 (System): Extension Park Hold Recall Timer
• FF1-0-02: Dial Control for Floating Hold Answer
Considerations
• You cannot park more than one call at a time.
• No more than one Call Park Answer key may be assigned to a single telephone.
• If two calls are on hold and the last call is parked, the other call is then considered the last held
call. If a transfer is performed, the remaining held call would be the call transferred, not the
parked call.
Call Pickup
Description
The System allows the following types of call pickup:
• Extension Group Pickup
• Extension Direct Pickup
• Trunk Group Pickup
• Trunk Direct Pickup
Extension Group Pickup
Extension Group Pickup allows you to pick up a direct ringing call (within your extension pickup
group or in a different pickup group) without having to dial the number of the ringing extension.
Three types of Extension Group Pickup are available:
• Call Pickup - All Calls: You can pick up a call ringing anywhere within your own extension
group.
• Call Pickup - External Calls: You can pick up only external calls ringing within your own
extension group.
• Specified Group Pickup: You can pick up a call ringing to an extension in another extension
group.
Action Result
1. At the extension with the transferred park call, lift the hand-
set or press the ON/OFF key.
Intercom dial tone
2. Enter the Call Park Answer/Self access code (default =
772).
• Connected to parked call
To Next Page