Section 700 - Operation Chapter 6. DSLT Features
576-50-700 DBS 576 (USA) issued September 2001 6-37
Operation
After receiving an offhook signal during a call:
Note:
For details about handling multiple calls, see “Call Hold” on page 6-16.
Hardware Requirements
•N/A
Related Programming
• FF3: CO Off-Hook Signal.
Considerations
• The CO call type may be either multiple ring, direct, or camp-on.
• The system does not send the offhook signal under the following conditions:
• During a conference call
• During an OHVA or Busy override
• Data Privacy is enabled
• the receiving telephone is a 3rd party voice mail.
Offhook Voice Announce
Description
You can interrupt a busy extension when making an Intercom Call, and then use the Off-Hook Voice
Announce (OHVA) feature to make an announcement that only the called party can hear. You can
also transfer a held call to a busy extension after making the announcement using this feature.
Operation
To make an OHVA:
Action Result
1. Press the HOLD key.
2. Press the flashing FF key for the CO line of the incoming
call.
Action Result
1. Lift the handset or press the ON/OFF key.
2. Dial the extension number. Busy signal
3. Enter the OHVA feature access code (default = 8).
4. Make your announcement
To Next Page
Loading...
