Panasonic DBS-576HD - Set Mode Schedule

Section 700 - Operation Chapter 4. User Maintenance
576-50-700 DBS 576 (USA) issued September 2001 4-15
Hardware Requirements
•N/A
Related Programming
•N/A
Considerations
•N/A
Set Mode Schedule
Description
(For a description of Automatic Day/Night System Mode, see “Automatic Day/Night Mode” on page
3-27.)
You can set the System to automatically enter None, Day 1, Day 2, Night, Night (1), or Night (2)
modes based upon mode patterns. You can define up to 3 patterns with up to 5 modes for each day.
(This menu allows the setting of the patterns.)
7. Enter the Message Key ID code.
Notes: The ID code may contain up to 16 digits and contain
0, 1-9, *, #, pause (REDIAL key).
To clear an entry or existing data, press the FLASH key.
8. Press the HOLD key to store the entry. Next extension number displays
9. To set additional Message Key ID codes, press the volume
up or down key or press the HOLD key to move to the
desired extension.
Desired extension number displays
10. Repeat steps 7-9 until all Message Key ID codes are set.
11. Press the AUTO key to exit the entry mode. MSGID - EXT Number displays
12. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
81-
User MAINT displays
OR...
ON/OFF LED goes off
Action Result