Panasonic DBS-576HD - Network Paging; Network Transfer Recall; Tandem Connection; Non-Blocking Architecture

3-48 DBS 576 (USA) issued September 2001 576-50-700
Chapter 3. System Features Section 700 - Operation
Related Programming
• FF1-0-04: Trunk COS (Broker’s Hold for Network Calls)
• FF1-1-01-0020: Network Flash Signal Timer
• FF1-2-02: FF Dial Codes: Plan A (Network Flash Send During Intercom Dial Tone)
• FF1-2-03: FF Dial Codes: Plan B (Network Flash Send During Intercom Dial Tone)
• FF4-0-BSSC-0: FF-Key Assignment (Network Flash During Talk on FF-key)
Network Paging
Network Paging allows users on one System to page on another System when the appropriate Class of
Service (COS) allows.
Network Transfer Recall
Network Transfer Recall allows a call which has been transferred to another node to recall back to the
transferring extension.
Tandem Connection
Tandem Connection allows calls that are received over the network tie lines to be automatically
routed on to another PBX or out to the public network.
Hardware Requirements
• T1 or E&M Card
Related Programming
• FF6: ARS/TRS
Considerations
•N/A
Non-Blocking Architecture
Description
The System is totally non-blocking. All extension and outside lines are available for use at the same
time.
Hardware Requirements
• The CPC-96 supports up to 96 ports. The CP-288 supports up to 288 ports and should be
combined with time switch card TSW288. The CPC-576 supports up to 576 ports and should be
combined with time switch card TSW576.
Related Programming
•N/A
Considerations
•N/A