Panasonic DBS-576HD - Direct Trunk Access; MCO Trunk Access

7-42 DBS 576 (USA) issued September 2001 576-50-700
Chapter 7. SLT Features Section 700 - Operation
Direct Trunk Access
Extensions can seize a specific trunk for outgoing calls. Extensions can also use Direct Trunk Access
to test trunks or to access data trunks.
Operation
To use Direct Trunk Access:
Hardware Requirements
•N/A
Related Programming
• FF1-0-03: Extension COS (Direct Trunk Access)
• FF3: Extension COS
Considerations
•N/A
MCO Trunk Access
The System supports up to 5 MCO groups for each MCO tenant group. You can seize an idle trunk
from the MCO trunk group by entering the MCO access code.
Operation
To seize an idle trunk:
Hardware Requirements
•N/A
Related Programming
• FF1: MCO Access
Action Result
1. Lift the handset.
2. Enter the Direct Trunk Access code (default = 88).
3. Enter the desired trunk number. Outside dial tone
4. Dial the phone number.
Action Result
1. Lift the handset. Intercom dial tone
2. Enter the desired trunk access number (9 or 81-84). (See
Table 2 on page 7-43.)
Outside dial tone
3. Dial the phone number.