Section 700 - Operation Chapter 5. Key Telephone Features
576-50-700 DBS 576 (USA) issued September 2001 5-97
Variable Mode
Description
Variable Mode allows you to use the soft keys on a display phone to access selected features when
your phone is in the following state:
• While receiving intercom Dial Tone or during dialing - up to 10 functions
• While receiving intercom ringback tone - up to 5 functions
• While receiving intercom busy tone - up to 10 functions
• While talking in intercom mode, during CO seizure, or during CO talk - up to 5 functions
Each extension may have customized soft key features available. The customization must be
programmed by the dealer.
To access the feature beside the soft key, simply press the associated soft key.
Operation
To enable Variable Mode:
To Execute a Variable Mode Function:
To cancel Variable Mode:
Action Result
1. Press the ON/OFF key.
2. Press the Variable Mode FF key AUTO FNC Mode displays
3. Press the ON/OFF key. Programmed features display
Action Result
1. Press the NEXT or PREV keys on the large display tele-
phone or the up or down arrow keys on the small display
telephones until the desired function appears
2. Press the soft key next to the desired function The variable mode function executes
Action Result
1. Press the ON/OFF key.
2. Press the Variable Mode FF key. AUTO FNC Mode displays
3. Press the ON/OFF key again.
To Next Page