4-6 DBS 576 (USA) issued September 2001 576-50-700
Chapter 4. User Maintenance Section 700 - Operation
Set Call Forward ID Codes for Voice Mail
Description
(For a description of Call Forward ID codes for Voice Mail, see “Call Forward ID Code for Voice
Mail” on page 3-62.)
Voice Mail Call Forward ID codes are used by voice mail systems to identify the correct mail box for
storing messages. The actual entry needed will vary by voice mail systems and configuration. Often
the entry is the extension number.
Operation
To set the Call Forward ID code:
Hardware Requirements
•N/A
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 4-3.)
81-
User MAINT displays
2. At the 81 level, enter 05.
3. Press the HOLD key. 8105-
C.FWD ID Code displays
4. Press the HOLD key. CF ID-EXT Number displays
5. Dial the extension number.
6. Press the HOLD key. CF-ID EXT XXX displays (where
XXX = extension number)
7. Enter the Call Forward ID code.
Notes: The ID code may contain up to 16 digits and contain
0, 1-9, *, #, pause (REDIAL key).
To clear an entry or any existing data, press the FLASH
key.
8. Press the HOLD key to store the entry. Next extension number displays
9. To set additional Call Forward ID codes, press the volume
up or down key or press the HOLD key to move to the
desired extension.
Desired extension displays
10. Repeat steps 7-9 until all Call Forward ID codes are set.
11. Press the AUTO key to exit the entry mode. CF ID-EXT Number displays
12. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
81-
User MAINT displays
OR...
ON/OFF LED goes off
To Next Page
Loading...
