10.8 Commissioning
10.8.1 Online Config Mode
When the online config mode is selected, the servo amplifiers are set to be connected to the
GM1 Controller
.
When using the online config mode, perform the setting as described in "10.3 Communication
Setting" in advance.
1. From the menu bar
, select Project>Online Config Mode.
A confirmation message will be displayed, asking whether to remove all applications.
2. Click [Yes].
All applications will be removed from the GM1 controller, and the GM1 controller and servo
amplifiers will be connected in online config mode.
While online config mode is in progress, "Online Config Mode" in the menu bar remains
selected.
● To cancel the online config mode, select Project>Online Config Mode from the menu bar
again.
10.8 Commissioning
10-22 WUME-GM1ETCSU-01
To Next Page
Loading...
