4.2 Operation Mode Switching
■
Switching to the RUN mode
There are the following two methods.
●
Press the operation button (▶) on the GM Programmer while the STOP LED is lit.
● Set the RUN/STOP switch on the GM1 Controller to RUN.
● The switch cannot be set to the RUN mode if an error that does not allow to continue operation
has occurred or if an exceptional situation has occurred.
■
Switching to the ST
OP mode
There are the following two methods.
● Press the stop button (■) on the GM Programmer while the RUN LED is lit.
● Set the RUN/STOP switch on the GM1 Controller to STOP.
4.2 Operation Mode Switching
WUME-GM1ETCSU-01 4-3
To Next Page
Loading...
