10.2 Creating a New Project
When creating a program using GM Programmer for the first time, create a new project. For the
new project, set a device and a programming language to be used.
This section describes how to create a new project.
Given below is an example that explains the procedure to create a project for the GM1
Controller (product number: AGM1CSEC16T/P) in Structured T
ext (ST) format.
1. Start GM Programmer
.
For details on how to start GM Programmer, refer to "6.3.1 How to start".
When GM Programmer is started, the Start Page will be displayed.
2. Select "New Project
" under "Basic Operations".
The "New Project" dialog box will be displayed.
10.2 Creating a New Project
WUME-GM1ETCSU-01 10-3
To Next Page
Loading...
