Read from file
Reads the parameter file (
"obj5") that was edited previously. If communication is
performed with the servo amplifier, object values will be reflected in the servo amplifier as
soon as they are changed.
Read default
Reads the standard default settings of the servo amplifier that were saved during
installation.
If communication is performed with the servo amplifier
, object values will be reflected in
the servo amplifier as soon as they are changed.
2. Select one of the three options above for reading the object settings and click the [OK]
button.
The Object window will be displayed.
3. After changing the object settings, click the
[EEP] button to write the object settings to the
EEPROM of the servo amplifier.
4. Click the [×] button on the Object window to close the Object window.
7.5 Object Window
WUME-GM1ETCSU-01 7-17
To Next Page
Loading...
