Panasonic KX-HDV430

When an Alarm Notification Appears in a Pop-up Message
To connect the Network Camera where the alarm occurred
1. Tap "OK" on the pop-up message.
Note
• Tap "Cancel" to not connect to the Network Camera.
• If you received an alarm during a video call, the call is automatically switched to a voice call.
Checking an Alarm
1. In standby mode, tap or , and then select "Call History"
2. Tap
.
*1
3. Tap an item to connect to the camera and view its video feed.
*1
A list of Network Cameras where an alarm has occurred is displayed.
Note
• To delete an item from the list, tap , tap the check boxes of the items you want to delete, tap ,
and then tap "OK".
Configuring an Alarm Notification
Alarm Notification Settings
1. In standby mode, tap or , and then select "Basic Settings".
2. Tap or , and then select "Network Camera".
3. Tap "Alarm Settings".
4. Tap "Notification".
5. Tap "Pop Up", and then tap "OK".
Alarm Disarm Period Settings
You can set the period of time in which other alarm notifications are stopped (disarmed) after an alarm
occurs.
1. In standby mode, tap
or , and then select "Basic Settings".
2. Tap or , and then select "Network Camera".
3. Tap "Alarm Settings".
4. Tap "Disarm Time".
5. Tap or : Set the disarm time (in seconds), and then tap "OK".
Alarm Port Number Settings
You can set the port number for receiving alarms.
1. In standby mode, tap or , and then select "Basic Settings".
2. Tap or , and then select "Network Camera".
3. Tap "Alarm Settings".
4. Tap "Port Number".
3.10.7 Receiving Alarms from Network Cameras
Document Version: 2017-08 Operating Instructions 87