LED Indication, Outside (CO) Line
Description The LED (Light Emitting Diode) indicators of the buttons
associated with outside (CO) lines show the line conditions using a
variety of lighting patterns. This allows the user to see which lines
are idle and which lines are in use. The table below shows the
lighting patterns for different line conditions.
Condition • Item with an * is only available on a Single-CO button.
Programming References
Station Programming . . . . . . . . . User Manual
Flexible Button Assignment – Group-CO (G-CO) Button,
Other-CO (O-CO) Button,
Single-CO (S-CO) Button
Feature References Section 3, Features
Button, Group-CO (G-CO) Button, Other-CO (O-CO)
Button, Single-CO (S-CO)
Operation References Not applicable.
CO Button
Off
Green On
Flashing Green Slowly
Flashing Green
Moderately
Flashing Red Rapidly
Red On
Flashing Red Slowly
Flashing Red Moderately
Outside (CO) Line Condition
Idle
The user is using the line.
The user has a held call or Hold Recall
The user has one of the following:
(1) exclusive hold, (2) outside-to-outside (CO-
to-CO) line call, or (3) Conference, Unattended.
Incoming call
Other-use
Other-hold
*
Local Carrier-Based Voice Mail Service*
Flashing light patterns
Flashing slowly
Flashing moderately
Flashing rapidly
To Next Page
Loading...
