System Programming 4-45
4.2 System Programming
Interdigit Time
208
Description Assigns the maximum time allowed between digits for an outgoing
outside call.
Selection 5 sec / 10 sec / 15 sec / 20 sec (seconds)
Default 10 sec
Programming 1. Enter 208.
Display: Interdigit Time
2. Press NEXT.
Display example: Time:10 sec
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Conditions • The interdigit timer applies until the toll restriction check is completed.
When the timer expires, an outgoing outside call will be disconnected
while dialing, if “Enable” was selected in program [211] “No Dial
Disconnection”.
• For a single line telephone, an outgoing outside call will be released
from a DTMF receiver when the interdigit timer expires.
Feature Reference Section 3, Features
Toll Restriction
To Next Page
Loading...
