4-112 System Programming
4.2 System Programming
Doorphone Access Tone Selection
707
Description Enables or disables sending a doorphone access tone to a monitored
doorphone. If enabled, the access tone is heard from the doorphone
when monitoring starts.
Selection • Doorphone number: 1 – 2, ( = all doorphones)
• Enable / Disable
Default All doorphones — Enable
Programming 1. Enter 707.
Display: Door Ack-Tone
2. Press NEXT.
Display: Door NO? →
3. Enter a doorphone number.
Pressing NEXT also can enter doorphone number 1.
Display example: DP-1:Enable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another doorphone, press NEXT or PREV, or
SELECT and enter the desired doorphone number.
7. Repeat steps 4 through 6.
8. Press END.
Condition • To assign all doorphones to the same selection, press the key in
step 3. In this case, the display will show: DP- :Mixed.
Feature References Section 3, Features
Doorphone Call
Room Monitor
To Next Page
Loading...
