3-112 Features
S 3 Features
Station Hunting
Description If a called extension is busy, Station Hunting redirects the incoming
call to an idle extension in the extension group. Idle extensions are
automatically searched according to programming. Two hunting
types are available as follows.
Circular hunting: The extensions are searched one time in
numerical order until an idle one is found. If all extensions are
busy, a busy tone will be heard. If the calling outside (CO) line
is assigned to DIL and all hunting group extensions are busy,
the call will be forwarded within the group until an extension
becomes idle.
Terminate hunting: The extensions are searched from the
destination jack until the call reaches the highest jack number in
the group. If all higher number jacks are busy, the search will
end and a busy tone will be heard. If the calling outside (CO)
line is assigned to DIL and all hunting group extensions are
busy, the call will be forwarded within the group until an
extension becomes idle.
One hunting type can be selected for each extension group.
To leave the hunting group temporarily, use the Log-Out function.
To rejoin, use the Log-In feature.
Condition • If the called extension has set Do Not Disturb, Call Forwarding or
Log-Out, Station Hunting will skip the extension. However, Station
Hunting will not skip the extension which receives the call first, even if
it has set Do Not Disturb or Call Forwarding.
Programming References
Section 4, System Programming
[100] Hunting Group Set
[101] Station Hunting Type
[600] Extension Group Assignment
Feature References Section 3, Features
Call Forwarding
Do Not Disturb
Extension Group
Log-In/Log-Out
To Next Page
Loading...
