4-46 System Programming
4.2 System Programming
No Dial Disconnection
211
Description Enables or disables disconnecting an outside (CO) line if an
extension user does not dial anything within 10 seconds after an
outside (CO) line is seized.
Selection Enable (disconnect) / Disable (does not disconnect)
Default Disable
Programming 1. Enter 211.
Display: No Dial Mode
2. Press NEXT.
Display example: Disable
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Condition • The interdigit timer assigned in program [208] “Interdigit Time” applies
until the toll restriction check is completed. When the timer expires, an
outgoing outside call will be disconnected while dialing, if “Enable”
was selected in this program.
Feature References None
To Next Page
Loading...
