4.2 System Programming
Caller ID Call Waiting Assignment
4-136 System Programming
Description Enables or disables the Caller ID Call Waiting feature for outside
(CO) lines which have contracted Caller ID Service with a Central
Office.
Selection • Outside (CO) line number: 1 – 3, ( = all outside (CO) lines)
• Enable / Disable
Default All outside (CO) lines — Enable
Programming 1. Enter 913.
Display: C.W CID Assign
2. Press NEXT.
Display: CO NO? →
3. Enter an outside (CO) line number.
Pressing NEXT also can enter outside (CO) line number 1.
Display example: CO 1:Enable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside (CO) line, press NEXT or
PREV, or SELECT and enter the desired outside (CO) line
number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all outside (CO) lines to the same selection, press the key
in step 3. In this case, the display will show: CO :Mixed.
• When “Disable” is assigned in program [900] “Caller ID Assignment”,
the Caller ID Call Waiting feature does not perform even if “Enable” is
assigned in this program.
Feature Reference Section 3, Features
Caller ID Call Waiting
913
To Next Page
Loading...
