3.2 Feature Programming References
824 PC Programming Manual
– Dialling Mode
– DTMF Width
– CO Pulse Speed
• 2.8.31 [1-1] Slot—Port Property - DID Port
– Dialling Mode
– DTMF Width
– CO Pulse Speed
Feature Guide Reference
1.5.4.4 Dial Type Selection
Direct In Line (DIL)
• 2.17.2 [10-2] DIL Table & Port Settings—DIL
– DIL Destination—Day, Lunch, Break, Night
– Tenant Number
– VM Trunk Group No.
Feature Guide Reference
1.1.1.2 Direct In Line (DIL)
Direct Inward Dialling (DID)/Direct Dialling In (DDI)
• 2.8.30 [1-1] Slot—Card Property - DID type
• 2.9.4 [2-3] Timers & Counters—Miscellaneous—Incoming Call Inter-digit Timer—DDI / DID
• 2.17.2 [10-2] DIL Table & Port Settings—DDI / DID / TIE / MSN
– Distribution Method
– DDI/DID/TIE/MSN—Remove Digit
– DDI/DID/TIE/MSN—Additional Dial
• 2.17.3 [10-3] DDI / DID Table
Feature Guide Reference
1.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
Direct Inward System Access (DISA)
• 2.9.4 [2-3] Timers & Counters—DISA / Door / Reminder / U. Conf
– DISA—Delayed Answer Timer
– DISA—Mute & OGM Start Timer after Answering
– DISA—No Dial Intercept Timer
– DISA—2nd Dial Timer for AA
– DISA—Intercept Timer—Day, Lunch, Break, Night
– DISA—Disconnect Timer after Intercept
– DISA—CO-to-CO Call Prolong Counter
– DISA—CO-to-CO Call Prolong Time
– DISA—Progress Tone Continuation Time before Recording Message
– DISA—Reorder Tone Duration
• 2.9.4 [2-3] Timers & Counters—Miscellaneous—Extension PIN—Lock Counter
• 2.9.11 [2-7-1] Class of Service—COS Settings—Extension Feature—Accept the Call from
DISA
• 2.10.1 [3-1-1] Trunk Group—TRG Settings—Tone Detection
To Next Page
Loading...
