224
Stabiliser, Zoom and Flash
Applicable modes:
You can set a flash type at [Firing Mode] in [Flash].
•
When [MANUAL] is set, the luminosity ratio ([1/1], etc.) is displayed on the flash icon on the
screen.
1 Select [Flash] in the [Rec] menu. (P40)
2 Press 3/4 to select [Manual Flash Adjust.] and then press [MENU/SET].
3 Press 2/1 to select an item and then press [MENU/SET].
•
You can set from [1/1] (full brightness) to [1/128] in steps of [1/3].
Applicable modes:
By using flashes that support the wireless control (DMW-FL360L: optional), you can
control firing of the built-in flash (or a flash attached to the hot shoe of this unit) and three
flash groups separately.
1 Set the external flashes to be controlled to RC Mode, and then place them.
•
Set the channel and groups for the external flashes to be controlled.
2 Select the menu.
3 Press 3/4 to select [Wireless] and then press [MENU/SET].
4 Press 3/4 to select [ON] and then press [MENU/SET].
•
When [Wireless] is set to [ON], [WL] is displayed on the flash icon on the recording
screen.
• When making detailed settings of the wireless flash, set the following from [Flash].
Changing the firing mode (Manual flash)
Item Description of settings
[TTL]
The camera automatically sets the flash output.
[MANUAL]
Set the luminosity ratio of the flash manually. In [TTL] you can shoot the
photograph you want even when shooting dark scenes that may
otherwise be too brightly lit by the flash.
Setting the luminosity ratio (When [MANUAL] is selected)
Setting the wireless flash
Preparations:
Open the flash by sliding the flash open lever of this unit.
Alternatively, attach a flash (DMW-FL360L: optional) to this unit.
[MENU] > [Rec]>[Flash]
To Next Page
Loading...
