231
Motion Picture
Applicable modes:
1
Start recording by pressing the motion
picture button.
A Elapsed recording time
B Available recording time
• Recording of motion picture appropriate for each mode is
possible.
• The recording state indicator (red) C will flash while
recording motion pictures.
• If approximately 1 minute elapses without an operation
being performed, part of the display will disappear. Press
[DISP.] or touch the monitor to make the display
reappear.
• When recording a motion picture, do not cover the
microphone with your fingers or other objects.
• Release the motion picture button right after you press it.
2
Stop the recording by pressing the motion picture button again.
• Still picture recording is also possible during the motion picture recording by fully
pressing the shutter button. (P233)
Recording Motion Picture
Enabling/disabling the motion picture button
[MENU] > [Custom]>[Video Button]>[ON]/[OFF]
•
This function is for preventing accidental operation of the button.
Switching between the angle of view for taking pictures and the one for
recording motion pictures
[MENU] > [Custom]>[Rec Area]>[!]
(Picture)/[ ] (Motion picture)
•
When the aspect ratio setting is different in still and motion pictures, the angle of view
changes at the start of motion picture recording. When [Rec Area] is set to [ ], angle of
view during motion picture recording is displayed.
• The recording area indicated is an approximation.
To Next Page
Loading...
