53
Preparation
• The [E-Shutter Vol] only works when [SH] for Burst Mode or [Electronic Shutter] is set to [ON].
• When you connect the camera to a TV, the volume of the TV speakers does not change.
• It will adjust the monitor when the monitor is in use, and the viewfinder when the viewfinder is in
use.
• Some subjects may appear differently from actuality on the monitor. However, this does not
affect the recorded pictures.
[Beep]
Set the volume for electronic noises and the electronic shutter
noise.
[Beep Volume]:
[u] (High)
[t] (Low)
[s] (OFF)
[E-Shutter Vol]:
[ ] (High)
[ ] (Low)
[ ] (OFF)
[Speaker Volume]
Adjust the volume of the speaker to any of the 7 levels.
[Monitor Display]/
[Viewfinder]
Brightness, colour, or red or blue tint of the Monitor/viewfinder is
adjusted.
[ ] ([Brightness]):
Adjust the brightness.
[ ] ([Contrast · Saturation]):
Adjust the contrast or clarity of colours.
[ ] ([Red Tint]):
Adjust the red tint.
[ ] ([Blue Tint]):
Adjust the blue tint.
1 Select the settings by pressing 3/4, and adjust with
2/1.
•
Adjusting can also be performed by rotating the rear dial.
2 Press [MENU/SET] to set.
To Next Page
Loading...
