EVOHD+ Installation Guide
41
Special System Reporting Codes
When the system generates one of the following events, the control panel can send the report code to the monitoring station identifying the event:
Special Arming Report Codes
When the partition arms using a special arming feature, the control panel can send the report code identifying how the system was armed.
[3900] Cold Start Control panel re-starts after complete shutdown (total power loss)
[3901] Warm Start Control panel resets due to sudden problem other than power loss
[3902] Test Report Report generated automatically (see section )
[3903] Listen-In to Follow Listen-In module attempts to start a Listen-In session
[3904]
BabyWare Login
Request
Communication attempted between BabyWare and control panel
(Callback only)
[3905] BabyWare Log Off Control panel ends communication with BabyWare
[3906] Installer In Installer enters programming mode
[3907] Installer Out Installer exits programming mode
[3908] to [3909]
Future Use
[3910] Auto-Arming When Auto-Arming (see section on page 32)
[3911] PC Arming System armed using BabyWare or NEware software
[3912] Late to Close When Auto-Arming (see section on page 32)
[3913] No Movement
When No Movement Auto-Arming
(see
section on page 33)
[3914] Partial Arming
When partitions are Stay, Instant or Force armed or armed with bypassed
zones
[3915] Quick Arming Partitions armed with a One-Touch Arming feature (see section on page 34)
[3916] Early to Close Partition armed before Arming Report Schedule (see section on page 44)
[3917] Late to Close Partition armed after Arming Report Schedule (see section on page 44)
[3918] Remote Arm
Partition armed with the InTouch Voice-Assisted Arm/Disarm Module
(VDMP3)
[3919]
Closing
Delinquency
Partition hasn’t been armed before the programmed Closing Delinquency
Timer elapsed (see
section on page 48).
To Next Page
Loading...
Need help?
General
