42
EVOHD+ Installation Guide
Special Disarming Report Codes
When using one of the special disarming features listed below, the control panel can send the report code identifying how the system was disarmed. Also, refer to
Disarm Reporting Options in section on page 48.
Special Alarm Report Codes
[3920] Cancel Auto-Arm Partition disarms during the Auto-Arm’s delay (see section on page 32)
[3921] Quick Disarm Partition disarms using One-Touch Disarming feature (see section on page 34)
[3922] PC Disarm System disarmed using BabyWare or NEware software
[3923]
PC Disarm after
Alarm
System disarmed using BabyWare or NEware software after an alarm occurs
[3924] Cancel Alarm
Indicates that an alarm was cancelled even though the system was not armed
when the alarm occurred.
[3925] Future Use
[3926] Early to Open Partition disarmed before Disarming Schedule (see section on page 44)
[3927] Late to Open Partition disarmed after Disarming Schedule (see section on page 44)
[3928] Remote Disarm Partition disarmed with InTouch Voice-Assisted Arm/Disarm Module (ADM2)
[3930]
Emergency Panic
(non-medical)
The panic keys [1] and [3] were pressed (see
section on page 38)
[3931]
Auxiliary Panic The panic keys [4] and [6] were pressed (see section on page 38)
[3932]
Fire Panic The panic keys [7] and [9] were pressed (see section on page 38)
[3933]
Recent Closing
An alarm is generated within the Recent Close Delay (see
section on page
47)
[3934]
Police Code
Confirmation of an alarm condition occurred during the Police Code Timer’s
delay (see
section on page 37).
[3935]
Auto Zone Shutdown
The control panel stops regenerating alarms on a zone during the same
armed period (see
section on page 24)
[3936]
Duress
A Duress enabled access code is keyed in (See “Appendix 3: Keypad
Installation Instructions” on page 75.)
[3937]
Keypad Lockout Too many invalid codes entered (see section on page 34)
To Next Page
Loading...
Need help?
General
