Basic system management configuration task list 100
SmartWare Software Configuration Guide 7 • Basic system management
When there are many VoIP units in the same location, use this command to flash all the LED’s on a specific
unit for a specified period of time. This makes identification of the physical unit very easy.
2 [name] (sys)#[no] terminal idle-time-
logout
After 30 minutes without user input, a terminal session
is automatically closed. If longer session periods are
required (logging/debugging) this command allows
to increase the session timeout, or to disable it com-
pletely.
3 [name] (sys)#terminal more Enables pausing of display for commands which pro-
duce more output than the current terminal window
can display at once.
4 [name] (sys)#terminal width Configures the terminal width.
Step Command Purpose
1 [name] #blink <seconds> Enter an integer for the period of time you want the
LED’s to flash on the physical unit.
Step Command Purpose
To Next Page
Loading...