Patton electronics SmartNode Series - Enable Push-Back - Bridge Service; Enable Push-Back - Distribution-Group Service; Enable Push-Back - Hunt Group Service; Enable Push-Back - Limiter Service

Call router configuration task list 518
SmartWare Software Configuration Guide 40 • Call router configuration
Enable push-back – bridge service.
Mode: context cs/service bridge
Enable push-back – distribution-group service.
Mode: context cs/service distribution-group
Enable push-back – hunt group service.
Mode: context cs/service hunt-group
Enable push-back – limiter service.
Mode: context cs/service limiter
Enable push-back – priority service.
Mode: context cs/service priority
Step Command Purpose
1 [name](svc-brdg)[service]#[no]
allows-push-back
Enables push-back of a call of this service.
Default is disabled.
Step Command Purpose
1 [name](svc-dist)[service]#[no]
allows-push-back
Enables push-back of a call of this service.
Default is disabled.
Step Command Purpose
1 [name](svc-hunt)[service]#[no]
allows-push-back
Enables push-back of a call of this service.
Default is disabled.
Step Command Purpose
1 [name](svc-lim)[service]#[no]
allows-push-back
Enables push-back of a call of this service.
Default is enabled.
Step Command Purpose
1 [name](svc-prio)[service]#[no]
allows-push-back
Enables push-back of a call of this service.
Default is enabled.