Frame Relay configuration task list 184
SmartWare Software Configuration Guide 15 • Frame Relay configuration
Displaying Frame Relay information
Since Frame Relay configuration for the serial interface is complex and requires many commands, it is helpful
to list the frame relay configuration on screen.
This procedure describes how to display the Frame Relay configuration settings for the serial interface.
Mode: Port serial
Example: Displaying Frame Relay information
The following example shows the commands used to display Frame Relay configuration settings.
node>enable
node#configure
node(cfg)#show framerelay
Framerelay Configuration:
Port LMI-Type Keepalive Fragmentation
----------------------------------------------------------
serial 0 0 0 ansi 10 disabled
PVC Configuration:
Port DLCI State Fragment Encaps Binding
--------------------------------------------------------------
serial 0 0 0 1 open disabled rfc1490 wan@router
Step Command Purpose
1 node(prt-ser)[slot/port]#show framerelay Displays Frame Relay information.
To Next Page
Loading...