Patton electronics SmartNode Series - Deleting Mapping Tables

To Next Page

To Previous Page

Call router configuration task list 484

SmartWare Software Configuration Guide 40 • Call router configuration

node(cfg)#context cs

node(ctx-cs)[switch]#mapping-table called-type-of-number to called-type-of-number

SET-INT

node(rt-tab)[SET-INT]#map default to international

Any called party number type matches the default entry. Note that the input-type of the table does not matter

when the mapping table contains only the default entry. Anyway an input-type must be speciﬁed when creat-

ing the mapping table.

The output (called party number type) is international.

The called party number type is set to international.

Example: Mapping table to replace called party numbers (translation table)

node(cfg)#context cs

node(ctx-cs)[switch]#mapping-table called-e164 to called-e164 TRANS

node(rt-tab)[TRANS]#map 550 to 250

node(rt-tab)[TRANS]#map 551 to 251

node(rt-tab)[TRANS]#map 552 to 252

node(rt-tab)[TRANS]#map 553 to 253

node(rt-tab)[TRANS]#map 554 to 254

node(rt-tab)[TRANS]#map 555 to 255

node(rt-tab)[TRANS]#map 556 to 256

node(rt-tab)[TRANS]#map 557 to 257

node(rt-tab)[TRANS]#map 558 to 258

node(rt-tab)[TRANS]#map 559 to 259

Note The translation table above can be reduced using regular expressions.

node(cfg)#context cs

node(ctx-cs)[switch]#mapping-table called-e164 to called-e164 TRANS

node(rt-tab)[TRANS]#map 55(.) to 25\1

Deleting mapping tables

To remove individual mapping tables you can use the

no form of the mapping table command. Alternatively

you can remove speciﬁc entries of a mapping table by entering the mapping table conﬁguration mode and use

the

no form of the map command.

Procedure: To delete an entry from a mapping table

Mode: Context CS

Step Command Purpose

1 node(ctx-cs)[switch]#mapping-table

table-name

Enter the mapping table from which you want to remove an

entry.

Note: You do not have to enter the type of the table when

just entering it. The type must only be speciﬁed when creating

a table.

2 node(map-tab)[table-name]#no map

key

Remove the entry with the speciﬁed key.

3 Repeat Step 2 to remove additional entries.

Main Page

Patton electronics SmartNode Series - Deleting Mapping Tables

Table of Contents