EasyManua.ls Logo

Patton electronics SmartNode Series - Sample Configurations; PPP over Ethernet (Pppoe); With Authentication, Encapsulation Pppoe; Without Authentication, Encapsulation Multi, with NAPT

Default Icon
655 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Sample configurations 327
SmartWare Software Configuration Guide 30 • PPP configuration
Service:
Access-Concentrator:
State: Opened
Sent Initiations: 1
Sent Requests: 1
Peer Session-ID: 3786
Peer MAC-Address: 00:01:02:B8:4E:E4
Sample configurations
PPP over Ethernet (PPPoE)
Without authentication, encapsulation multi, with NAPT
profile napt WAN
context ip router
interface normal_ip_interface
ipaddress 172.16.1.1 255.255.0.0
interface ppp_interface
ipaddress unnumbered
point-to-point
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
use profile napt WAN
context ip router
route 0.0.0.0 0.0.0.0 ppp_interface 0
port ethernet 0 0
encapsulation multi
bind interface normal_ip_interface
no shutdown
pppoe
session green
bind interface ppp_interface
no shutdown
With authentication, encapsulation PPPoE
context ip router
interface ppp_interface
ipaddress unnumbered
point-to-point
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
subscriber ppp joe_example
dial out
authentication pap

Table of Contents