Patton electronics SmartNode Series - Configuring Basic Dyndns Settings; Configuring the Dyndns Server

To Next Page

To Previous Page

DynDNS configuration task list 308

SmartWare Software Configuration Guide 29 • DynDNS configuration

Conﬁguring basic DynDNS settings

The following procedure describes the steps necessary to enable the DynDNS feature.

Mode: DynDNS

Example: Conﬁguring DynDNS

The following example shows the necessary steps required for a basic working conﬁguration of the

DynDNS client.

node>enable

node#configure

node(cfg)#context ip

node(ctx-ip)[router]#dyndns

node(dyndns)#authentication Bob 245gf46te

node(dyndns)#service dynamic

node(dyndns)#hostname myhostname.dyndns.org

node(dyndns)#observe eth1

Conﬁguring the DynDNS server

A DynDNS server other than “dyndns.org” can be conﬁgured in case you or your provider runs an own

DynDNS server.

Mode: context cs/dyndns

Step Command Purpose

1 node(dyndns)#authentication user pass-

word

Deﬁnes the authentication credentials of your

DynDNS account

2 node(dyndns)#service

{dynamic|static|custom}

Deﬁnes the DynDNS service to use

3 node(dyndns)#hostname name Deﬁnes the hostname that will be assigned to the

SmartNode

Step Command Purpose

1 [name](dyndns)# server [<server-

name>]

Set the DynDNS server name. The default value is

“dyndns.org”.