Introduction 597
SmartWare Software Configuration Guide 49 • SIP profile configuration
Introduction
The SIP profile specifies disconnect cause mappings from SIP codes to Q.931 causes, and vice versa. As for all
profiles, there is a default profile at system startup that can be modified. Only those causes that differ from the
default mapping have to be configured. If a new profile is created, all mappings are set to their default and are
only overwritten if configured. The default mapping in both directions is according to RFC3398 - ISUP to SIP
Mapping.
A SIP profile can either be attached to SIP interfaces or to identities. To see how to configure a SIP profile for
an interface, see Chapter 39, “SIP interface configuration” on page 436. For information about SIP profile
configuration for identities, see Chapter 51, “Location Service” on page 602.
SIP profile configuration task list
This section describes the configuration tasks for SIP profile listed below.
• Enter the configuration mode for a SIP profile (see page 597)
• Map from a SIP disconnect cause to a Q.931 cause (see page 597)
• Map to a SIP cause from a Q.931 disconnect cause (see page 598)
• Map from a SIP redirection code to a Q.931 redirect reason (see page 598)
• Map to a SIP redirection code from a Q.931 redirect reason (see page 598)
Entering the configuration mode for a SIP profile
The profile sip command enters the configuration mode of an existing profile or creates a new one with a spec-
ified name. It also destroys an existing profile except the default, which always exists.
Mode: Configure
Mapping from a SIP disconnect cause
The map cause from-sip command maps a specific SIP disconnect cause to a Q.931 cause used by the call con-
trol. All causes are pre-defined in the system and are provided by the command.
Mode: Profile SIP
Step Command Purpose
1 [name](cfg)#[no] profile name <name> Creates/Destroys a SIP profile or enter the con-
figuration mode of an existing one.
Step Command Purpose
1 [name](pf-sip)[name]#map cause from-
sip sip-cause to q931-cause
Maps a specific SIP disconnect cause to a
Q.931 cause.
To Next Page
Loading...