Patton electronics SmartNode Series - Configuring Call Waiting (Optional); Configuring Ringback Tone on ISDN User-Side Interfaces; Disabling Call-Waiting on ISDN DSS1 Network Interfaces

To Next Page

To Previous Page

ISDN interface configuration task list 391

SmartWare Software Configuration Guide 34 • ISDN interface configuration

Example: Conﬁgure an alternate PSTN proﬁle

The following example shows how to replace the PSTN proﬁle default of the ISDN interface with the PSTN

proﬁle myproﬁle.

node>enable

node#configure

node(cfg)#context cs

node(ctx-cs)[switch]#interface isdn myIsdnIf

node(if-isdn)[myIsdnIf]#use profile pstn myprofile

Conﬁguring ringback tone on ISDN user-side interfaces

If a ring-back tone needs to be played towards the PSTN from an ISDN user-side interface, this can be forced

using the following command.

Mode: interface isdn <if-name>

Conﬁguring call waiting (optional)

The term “call waiting” is used as follows in this context: If the port bound to this interface is conﬁgured to be

network side, and both ISDN B-Channels are engaged with calls, and there is a new outgoing call over this

interface, the interface can

a) Signal the new call to all connected terminals, although both B-Channels are in use. One terminal can then

put its current call on hold to accept the new one (putting the call on hold frees its B-Channel).

b) Not signal the new call, because there is no B-Channel available. This is the desired behavior particularly if

the bound port is part of a hunt-group, and no user terminals are connected.

Default behavior is a), using the command below in the inverted form, behavior b) is selected.

Procedure: To conﬁgure call waiting

Mode: Interface ISDN

Disabling call-waiting on ISDN DSS1 network interfaces

This procedure disables support for call-waiting on an ISDN DSS1 network interface.

Mode: interface isdn <if-name>

Step Command Purpose

[name] (pf-isdn)[if-name]# [no] user-side-

ringback-tone

Enables ringback tone to be played on ISDN user-

side interfaces. Default: disabled.

Step Command Purpose

node(if-isdn)[if-name]#[no] call-waiting Enable/disable call waiting feature as described

above (default: enabled)

Step Command Purpose

[name] (if-isdn)[if-name]# no call-waiting Disable call-waiting.