Patton electronics SmartNode Series - Dial-Up Nailed; Dial-Up on Monitor

To Next Page

To Previous Page

PPP Dial-up over ISDN 336

SmartWare Software Configuration Guide 30 • PPP configuration

Dial-up on monitor

Dial when a monitored interface is reported down and drop when that interface is reported up again. A delay

time prevents to dial or drop if the monitored interface changes the state only for a short time.

Mode: context ip/interface

Dial-up nailed

Dial if possible, and never drop.

Mode: context ip/interface

Step Command Purpose

1 [name] (if-ip) [interface]#[no] dial-up mon-

itor interface <ip-interface> [dial delay

<seconds>] [drop delay <seconds>]

[queue-limit <number>]

Conﬁgure dial-up to monitor the interface

speciﬁed. Dial delay speciﬁes the timeout

before dialing (Default 10). Drop delay speci-

ﬁes the timeout before dropping connection

(Default 10). Queue-limit speciﬁes the max.

number of packets to queue while the link is

down (Default 4).

Step Command Purpose

1 [name] (if-ip) [interface]#[no] dial-up

nailed [queue-limit <number>]

Conﬁgure dial-up nailed. Queue-limit speci-

ﬁes the max. number of packets to queue

while the link is down (Default 4).