Patton electronics SmartNode Series - Registration Outbound Face

To Next Page

To Previous Page

Location Service configuration task list 608

SmartWare Software Configuration Guide 51 • Location Service

Registration outbound face

The registration outbound face is used to register an identity on an external registrar. Then, the registrar for-

wards calls from the registered identity to your identity.

Mode: Identity

Mode: Registration outbound

Step Command Purpose

1 [node](identity)[name]# [no] registration

outbound

Adds a new face to the identity. The no form of the

command removes an existing face with all content

in it.

Step Command Purpose

1 [node](regout)# [no] register [auto|none] Enables registration with auto or disables registra-

tion explicitly with none.

Step Command Purpose

1 [node](regout)# [no] registrar <host>

[<port>]

Conﬁgures the address of the registrar to send

your register requests. When no registrar is conﬁg-

ured, the register requests are sent to the ﬁrst

domain entry in the location-service.

Step Command Purpose

1 [node](regout)# [no] lifetime <seconds> Conﬁgures the desired lifetime of the registration.

When no lifetime is conﬁgured the desired lifetime

is set to 3600 seconds.

Step Command Purpose

1 [node](regout)# [no] retry-timeout (on-cli-

ent-error|on-sysstem-error|on-server-

error) <seconds>

Conﬁgures the time to wait after a failed registra-

tion according to three different error categories.

After this time we begin to register from new. If no

retry-timeout is conﬁgured the retry-timeout is set to

10 seconds.