PRI port configuration task list 199
SmartWare Software Configuration Guide 16 • PRI port configuration
Mode: Operator execution
Mode: Operator execution
PRI Configuration Examples
Here is a group of seven configuration examples.
• Example 1: ISDN
• Example 2: RBS without a channel-group
• Example 3: RBS with a channel-group
Step Command Purpose
1 [name]#[no] debug hw-type
[ ( [<slot> | [<port>] ] ) | [ [event] |
[error] ] ]
Enables/Disables the PRI event/error monitor for the
device a slot or a port.
Examples:
1)[no] debug e1t1
Enables/Disables the event and the error monitor for
all e1t1 ports of the device.
2)[no] debug e1 event
Enables/Disables the event monitor for all e1 ports
of the device.
3)[no] debug t1 error
Enables/Disables the error monitor for all t1 ports of
the device.
4)[no] debug e1 3
Enables/Disables the event and error monitor for all
e1 ports on slot 3.
5)[no] debug e1t1 1 event
Enables/Disables the event monitor for all e1t1
ports on slot 1.
6)[no] debug t1 2 error
Enables/Disables the error monitor for all t1 ports
on slot 2.
7)[no] debug t1 0 0
Enables/Disables the event and error monitor for the
t1 port 0 on slot 0.
8)[no] debug e1 1 0 event
Enables/Disables the event monitor for the e1 port 0
on slot 1.
9)[no] debug e1t1 2 0 error
Enables/Disables the error monitor for the e1t1 port
0 on slot 2.
Step Command Purpose
1 [name]#show port hw-type
[ [<slot> <port>] | [detail <level>] ]
Prints information about the specified port with a
given detail level.
To Next Page
Loading...