Patton electronics SmartNode Series - Enabling an Interface to Receive RIP; Enabling RIP Announcing

To Next Page

To Previous Page

RIP configuration task list 245

SmartWare Software Configuration Guide 23 • RIP configuration

The following example shows how to enable RIP learn host and default on IP interface wan.

node(cfg)#context ip router

node(ctx-ip)[router]#interface wan

node(if-ip)[wan]#rip learn host

node(if-ip)[wan]#rip learn default

Enabling an interface to receive RIP

This procedure describes how to enable receive RIP on an IP interface

Mode: Interface

Example: Enables an interface to receive RIP

The following example shows how to enable receive RIP for IP interface lan.

node(cfg)#context ip router

node(ctx-ip)[router]#interface lan

node(if-ip)[lan]#rip listen

Enabling RIP announcing

The RIP protocol supports announcing features, which are used to proclaim speciﬁc routing information to

other elements in a network. The RIP announcing command is used for this purpose and offers options for

• default—for RIP default routes,

• host—for IP host routes,

• self-as-default—for self as RIP default routes and

• static—for static IP routes.

Depending on the RIP announcing method the last option for the command in 3 must be explicitly selected. It

is possible to have more than one RIP announcing method enabled concurrently.

This procedure describes how to enable RIP announcing on an interface

Mode: Interface

Example: Enabling RIP announcing

The following example shows how to enable the RIP default routes and IP host routes RIP announcing

method on IP interface wan.

Step Command Purpose

1 node(if-ip)[name]#rip listen Enables receive RIP on IP interface name

Step Command Purpose

1 node(if-ip)[name]#rip announce {default | host | self-

as-default | static}

Selects the RIP announcing

method on interface name