H.323 interface configuration task list 435
SmartWare Software Configuration Guide 38 • H.323 interface configuration
The following commands can be used to change the AOC-D over H.323 tunneling behavior on an H.323
interface:
Mode: context cs/interfce h.323 <interface-name.
Step Command Purpose
1
node(if-h323)[if-name]# [no] aoc-d
accept
Enables or disables reception of AOC-D infor-
mation in FACILITY messages received in calls
over the current interface.
Default: Reception is disabled.
When enabled, Advice of Charge informa-
tion is received and accepted from the other
side of the gateway.
2
node(if-h323)[if-name]# [no] aoc-d emit Enables or disables transmission of AOC-D
information in FACILITY messages received
from the other side of the gateway.
Default: Transmission is disabled.
When enabled, the H.323 gateway sends
FACILITY messages containing AOC-D PDUs
whenever the charge of a call changes.
To Next Page
Loading...