Examples 590
SmartWare Software Configuration Guide 47 • VoIP profile configuration
G.711 u-law: rxlen=20;txlen=20
G.723 6k3: rxlen=30;txlen=30
Fax Transmission
Modem Transmission
Dejitter
--------
Mode: Adaptive
Max. Delay: 60ms
Max. Packet Loss: 4/1000
Shrink Speed: 1
Grow Step: 1
Grow Attenuation: 1
High Pass Filter: enabled
Post Filter: enabled
Fax
---
Detection: CED Tone
T.38 High Speed Redundant Packets: 0
T.38 Low Speed Redundant Packets: 0
Max. Bit Rate: 14400bps
Volume: -9.500dB
Error Correction: enabled
HDLC: enabled
Dejitter Max Delay: 200ms
Modem
-----
Max. Bit Rate: 14400
Volume: -9.500dB
HDLC: enabled
DTMF
----
Relay: disabled
Mute Encoder: disabled
RTP
---
Payload Type NTE: 101
Description:
3. Create VoIP profile and give it a name. All settings have default values
4. Remove the default codec G.711alaw that is not supported.
5. Add codec g723-6k3 without silence-suppression
To Next Page
Loading...