76180 EM -57/73-
⑤ FW version (CPU, DSP) will be appeared on the LCD monitor as shown in the figure.
If you cancel the updating, disconnect the all power at this point.
⑥ Remove the CF card when the message [>>> EJECT CF CARD <<<] is appeared then
starting updating. (It takes approx 60sec for loading firmware)
[CAUTION] Do not turn OFF the camera while loading.
⑦ Turn the main switch to OFF when the following message [POWER OFF] is appeared.
(Updating is completed)
⑧ Insert the CF card into the camera again then
turn on the power condition with opening CF
card cover.
⑨ Confirm that the latest version is displayed on
CURRENT version. (Example: VER.1.00.00.15)
⑩ Remove battery and disconnect AD adapter
without removing the CF card.
⑪ At the last remove the CF card.
3. Updating Firmware Version (2)
[Required equipment] Latest product Firmware for customer update (CF card),
AC adaptor (D-AC10), full capacity of battery.
[CAUTION] If power is shut down during updating firmware, electric part in the camera will
be damaged. For safe, use two type of power source.
[CAUTION] When executing this updating, the camera will not reset customers setting.
① Install the battery and connect the AC adaptor to the camera.
② Insert the CF card into the camera.
③ Closes the CF card cover.
④ Turn the main switch to ON while pressing [MENU] button.
⑤ When program update screen is displayed as shown in figure.
Select [YES] by pressing the four-way key then press OK.
Update will be started. (It takes approx. 60sec for loading
firmware)
* FW version for customer is displayed at this point.
[CAUTION] Do not turn OFF the camera while loading.
⑥ When [COMPLETE] is displayed, turn the camera OFF.
(Updating is completed)
PENTAX *IST D
UPDATING DSP FIRMWARE
SECTOR** >> PROGRAM
_____________
NEVER POWER OFF
PENTAX *IST D
UPDATING DSP FIRMWARE
････ COMPLETE ････
VERSION 1.00.00.12
POWER OFF
NOW LOADING
PROGRAM UPDATE
YES
NO
CURRENT VERSION 1.00
UPDATE VERSION 1.00
UPDATING
P**** 2/2
COMPLETE
To Next Page
Loading...
Need help?
General
