76700 -91/94-
AC adaptor (D-AC10)
USB cable (I-USB17)
Video cable (I-VC28)
Color video monitor (With a video input terminal)
Clean wipe-P (For CCD cleaning paper) 60boxes: No.95901-A14
1 boxes : No.95901-A15
Light source for AE adjustment
* Light value should equipped [LV6・8・10・12・16] or [LV6・9・12・15].
AE master lens for LX (LML-240, 95901-D20 can be used ) No.95901-N27
AF positioning jig (Square) for 27830 No.95901-M521
AF positioning jig (Cross) for 27250 No.95901-M514
2m AF 2 charts for 27830 (Attached in the service manual for 27830)
Focus master lens for 2m (ML-259) No.95901-N24
1
st
mirror angle adjusting jig for 45° No-95901-J104
2
nd
mirror angle adjusting jig for 27830 No.95901-J137
(Additional processing is required, refer to the additional processing)
Mirror positioning scope No.95901-N49
Hexagonal driver 1.5mm (HD-M1.5) No.95901-K72
FA(F) 35-80mm F4-5.6 (For AF adj)
D-FA Macro 50mm F2.8 (For AF adj)
FA 50mm F1.4 (For checking)
Remote control F (For checking)
Cable release swich CS-205 (For checking)
Jig for flash pop-up (Hand made, same as 27550 MZ-7)
Hexagonal driver 0.9mm (HD-M0.9) For flash positioning adj No.95901-K283
Collimator chart with 3 lines (OCRC-259, For checking AF focus) No.95901-M21
Focus master lens for 35mm (KMK-01) No.95901-N17
Dial gauge comparator (PH-2) No.95901-N1
Block gauge for 35mm (229N-A01-A2) No.95901-N4
Mount block (1620-A) / mount block spacer No.95901-N47
Mount block spacer (23600N-A01, A104-A-A)
Mount spacer holder (23600N-A01, A104-A-B) No.95901
1000mm Collimator
Pen light (For checking photo sensor)
Regulated DC power supply (capable current at least 3A and 8V)
Circuit tester
To Next Page
Loading...
