Pentax K10D - Page 128

126
4
Function Reference
5 Under the light to adjust the white balance, fully display a
white sheet of paper in the viewfinder or select a white
area as the subject.
6 Press the shutter release
button fully.
Slide the focus mode lever to \
when the shutter cannot be released.
The screen to select the measuring
range is displayed.
7 Use the rear e-dial to select the entire screen or spot area
for the measuring range.
Proceed to Step 9 if the entire screen is selected.
8 Use the four-way controller (2345) to move the frame
to the area you want to measure.
9 Press the 4 button.
The White Balance fine-tuning screen
appears when measuring is completed.
Tune using steps in “Fine-Tuning the
White Balance” if fine-tuning is
necessary. (p.123)
10 Press the 4 button.
The camera returns to the White Balance screen.
11 Press the 4 button twice.
The camera is ready to take a picture with the set White Balance.
• No image is recorded when the shutter release button is pressed to adjust
the white balance.
• [NG] appears when measuring is unsuccessful. Press the 4 button while
displayed to return to the White Balance fine tune screen.
• If the picture is extremely overexposed or underexposed, white balance may not be
adjusted. In this case, adjust appropriate exposure and adjust the white balance.
OK
O K
OK
OK
±0±0±0±0
±0±0
Manual
M a n u a l
White Balance
W h i t e B ala n c e
Manual
White Balance
GG
BBA
A
A
MM
SHUTTER
OK
O K
OK
OK
Cancel
C a n c e l
Cancel
MENU