149
4
Function Reference
2
Turn the rear e-dial and adjust
the sensitivity.
The shutter speed, aperture value and
sensitivity are displayed in the
viewfinder and on the LCD panel.
• You can set the sensitivity to values equivalent to ISO 100 to ISO 1600.
[AUTO] is not available.
• Turn the front e-dial while pressing the m button and change the EV
Compensation value. (p.161)
• Set the sensitivity in increments of 1/2 EV or 1/3 EV. Set in [EV Steps] in the
[A Custom Setting] menu. (p.162)
• You cannot set the sensitivity in [Sensitivity] in the Fn menu.
• Set the aperture to the s position while
holding down the auto-lock button when
using a lens with an aperture ring.
Exposure Warning
If the subject is too bright or too dark,
the sensitivity will blink in the viewfinder
and on the LCD panel. If the subject is
too bright, lower the sensitivity. If it is
too dark, raise the sensitivity. When the sensitivity value indication
stops blinking, you can take the picture with proper exposure.
Use an ND (Neutral Density) filter if the subject is too bright.
Use a flash if it is too dark.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
